Small scale quarry jaw crusher capacity reference data
Small scale quarry jaw crushers are widely used for primary crushing of granite, basalt, river pebble, limestone and other quarry stones. The actual output is affected by rock hardness, feed size, closed-side setting (CSS), feeding uniformity and moisture content. The data below is for reference only.
表格
| Model | Max feed size (mm) | Discharge adjustment range (mm) | Theoretical capacity (t/h) | Motor power (kW) | Weight (t) |
|---|---|---|---|---|---|
| PE 150×250 | 125 | 10-40 | 1-4 | 5.5 | 0.8 |
| PE 200×300 | 180 | 20-60 | 2-6 | 7.5 | 1.2 |
| PE 250×400 | 210 | 20-80 | 5-20 | 15 | 2.8 |
| PE 400×600 | 340 | 40-100 | 16-60 | 30 | 6.5 |
| PE 500×750 | 425 | 50-100 | 40-110 | 55 | 10 |
Notes:
- The capacity above is calculated with medium-hard limestone under continuous feeding. For hard rock like basalt or quartzite, the actual output needs to be reduced by 20%–40%.
- Small mobile jaw crusher (portable type) usually adopts PE250×400 / PE400×600 host, with 10%–20% lower capacity than fixed version due to chassis vibration limit.
- If the feed contains a lot of fine powder or sticky wet stone, throughput will drop obviously.
Key factors affecting small quarry jaw crusher output
- Rock compressive strength: Higher hardness means lower crushing efficiency.
- Feed size: Raw material larger than the maximum feed opening will cause frequent blockage and reduce production.
- Closed side setting: Smaller discharge gap gets finer product but lower hourly capacity.
- Feeding method: Continuous and even feeding reaches rated capacity; intermittent feeding greatly cuts output.
- Wear parts condition: Worn jaw plates will decrease crushing force and product yield.
Typical matching suggestions for small quarry
- Mini quarry, output requirement 1–5 t/h: PE150×250
- Small quarry, 5–20 t/h aggregate: PE250×400
- Medium small quarry, 20–50 t/h stone production: PE400×600